| Customization: | Available |
|---|---|
| Material: | Polyamide(Nylon 6.66)/PA |
| Usage: | General Plastics, Engineering Plastics, Specialty Plastics |
|
Still deciding? Get samples of $ !
Request Sample
|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
Unreinforced, Super tough , Polyamide 6 resin TOUGHENED PA6
PRODUCTION PROPERTIES
D TA10 NC is non-reinforced , injection molding-grade polyamide (nylon)6 with excellent molding
characteristics . Super tough, high flexibility, enhanced impact strength even in the dry and -40°C low temperature
conditioned state .
TYPICAL APPLICATIONS/ END USES
Side window crank, cable clips, safty belt covers, wall-pegs, dowels, tool-
handles
PROCESSING GUIDELINES
MATERIAL HANDLING :
PA (nylon) materials must be properly dried in order to provide parts with optimum strength and toughness. Nylon
materials are hygroscopic and will become degraded by excessive moisture during the injection molding process.
Products is supplied in moisture-protected containers and drying prior to molding is not required. If drying becomes
necessary, a dehumidifying or desiccant dryer operating at 80 °C (176 °F) is recommended. Drying time is dependent
on moisture level, but 4-6 hours is generally sufficient, but final moisture content must be less than 0.2%.
TYPICAL PROFILE :
Melt Temperature ;220-240 °C
Mold Temperature : 70-90 °C but temperatures of as low as 45 °C and as high as 105 °C can be used where
applicable
Injection Pressure 60-90MPa
FILL RATE:
Fast fill rates are recommended to ensure uniform melt delivery to the cavity and prevent premature freezing. Surface
appearance is directly affected by injection rate
NOTE:
Although all statements and information in this publication are believed to be accurate and reliable, they are
presented gratis and for guidance only, and risks and liability for results obtained by use of the products or
application of the suggestions described are assumed by the user. No warranties of any kind, either express or
implied , including warranties of merchantability or fitness for a particular purpose, are made regarding products
described or designs, data or information set forth
){kind=link}